Can you hook an amp up to a factory car stereo?
The best way to connect it to a factory system is to tap into the stereo’s speaker outputs for the amp’s input signal. Then send the amp’s outputs back to the stereo’s harness, and on to the speakers through the factory wiring. These cables will act like a “T-harness” to connect your amp to the factory system.
How do you hook up a car amp?
Your Step-By-Step Guide
- Step 1: Disconnect the Car Battery.
- Step 2: Mount the Amp.
- Step 3: Install the Power Wire.
- Step 4: Install the Fuse Holder.
- Step 5: Connect the Power Wire.
- Step 6: Install the Ground Wire.
- Step 7: Plug in RCA, Speaker, and Remote Turn-On Leads.
- Step 8: Turn It On.
Do I need to hook up power antenna wire?
Yes, these two wires should be connected together. This is what allows the radio to retract the antenna when it isn’t being used. Just because your wiring harness has a connection for this wire, it doesn’t necessarily mean that your car has this kind of motorized antenna.
Where do you connect the remote wire for an amp?
The turn-on wire (also called the remote wire) is located behind the stereo. On aftermarket stereos, it’s usually a blue and white wire. The remote wire will “tell” your amplifier to turn on whenever the stereo is powered up (usually, whenever the vehicle is turned on).
Can I hook up a subwoofer to my stock car stereo?
For us humans, that just means you’ll get phenomenal sound ALL while keeping your factory stereo and controls. So now you know – it’s definitely possible to install a subwoofer and amplifier to your factory system, and still have it sounding good.
Can you install an amp without RCA jacks?
Don’t worry as you can still install an amp without using RCA cables. You just have to make sure that the factory radio can accept speaker-level inputs or line-level connections. The RMS power of the amp should be less than or very close to the factory speaker. Otherwise, it will damage the running speakers.
Can you hook up subwoofer without amp?
Subwoofers are designed to increase the bass frequencies, resulting in a deep, thumping sound. In most cases, they are paired with an amplifier to boost the sound. If you do not have the funds for both components, you can still hook up a subwoofer without an amplifier; it simply involves a little more know-how.
Can you hook up a subwoofer to a factory radio?
In techie terms: …it takes amplified speaker level signals and converts them into high quality preamp signals that can be fed into an amplifier. So now you know – it’s definitely possible to install a subwoofer and amplifier to your factory system, and still have it sounding good.
Can you hook up home speakers in a car?
Although using a power supply to hook up a car stereo in the house is one way, you can do it even it if you don’t have a PSU. You connect the speakers to your car stereo using the gray and green wires. You may need to use extra speaker wire.
How do I hook up an amp to my car?
Connect the amplifier’s +12 volt power cable to the electrical system of your vehicle. Connect the ground from the amplifier to the chassis. Power on your car and stereo system and test your subwoofer for output. If the sound is scratchy, check that your connections are secure.
How do you wire a car stereo system?
On the car stereo, twist the red and yellow wires together. After you do that, connect the black ground wire on the stereo to the black wire on the pin connector. The stereo’s red and yellow wires connect to the connector’s yellow wire. You then follow the typical instructions to hook the stereo up to your speakers.
How do you hook up amp to car speakers?
Connect the speaker wires from the amplifier to the speakers. Situate these wires away from the power wires. Connect the amp’s negative terminal to the car’s chassis ground. Use a short negative power wire that is the same diameter as the positive wire that leads to the battery.