Categories :

Does Hobart make a plasma cutter?

Does Hobart make a plasma cutter?

The Hobart 500564 AirForce 12ci Plasma Cutter with Built-In Air Compressor runs on 120V input power. The Hobart AirForce plasma cutter comes with a fan that only runs when needed, reducing the dust and debris that is pulled into your machine.

How much is a Hobart plasma cutter?

Hobart 500564 Airforce 12ci Plasma Cutter with Built-In Air Compressor 120V , Brown

List Price: $899.99 Details
You Save: $60.00 (7%)

Do all plasma cutters need air compressor?

Plasma cutters need air pressure to cut in a two-stage process. Therefore, all plasma cutters need an air compressor to generate enough air pressure for the task. If you buy a plasma cutter without a built-in source of air, you’ll need a separate air compressor.

Are cheap plasma cutters any good?

The Lotos LTP5000D 50Amp Non-Touch Pilot Arc Plasma Cutter is our top pick due to its excellent high-quality cut over a broad range of plate thicknesses, regardless of the surface quality, it cuts through. We consider the SUPER DEAL DC Inverter Plasma Cutter the best of the lowest price-range models.

Are Hobart plasma cutters any good?

Though lightweight, the Hobart plasma machine boasts a powerful performance due to the built-in air compressor feature. Overall, this is a great, moderately priced plasma cutter which is perfect for light to medium duty cutting.

What is needed for a plasma cutter?

Plasma cutting requires two basic elements — air and electricity — so the next question to ask is what type of input power is available. Several 30-amp plasma cutters, such as the Spectrum® 375 X-TREME™, operate using 120- or 240-volt power.

Can you look at a plasma cutter?

Don’t stare at the bright light! Plasma cutting arcs can also be very intense, because the arc current is typically anywhere from 100 to 800 Amperes. Needless to say, looking at an arc that intense can easily cause eye damage, including permanent damage leading to blindness.

What size breaker do I need for a plasma cutter?

Usually 8 for 40 amps and 6 for 60 amps. I have the same Plasma Cutter you will really like it.

Do you need gas to run a plasma cutter?

Gas is needed for a plasma cutter in order for it to work and create the plasma. As mentioned, the most popular gases to use are oxygen, nitrogen or argon. Nitrogen is the best choice when it comes to cutting aluminium and stainless steel and it can provide an excellent cut quality.

Why are plasma cutters so expensive?

The surface will need to be ground off before applying weld metal. The price of a High Definition Plasma cutting machine is larger than other machines, but you get what you pay for. The cut parts produced from low cost air systems have significantly beveled edges.

Do I need gas for a plasma cutter?

Plasma cutters work by sending an electric arc through a gas that is passing through a constricted opening. The gas can be shop air, nitrogen, argon, oxygen.