How deep can a 2 HP well pump go?
A two-line jet pump can typically raise water from depths of 30-feet to 80-feet, and at water delivery rates of 4 gpm (gallons per minute) (for a 1/2 hp 2-line jet pump serving an 80 foot deep well) to 16 gpm (for a 1 hp 2-line jet pump serving a 30 foot deep well).
What size submersible pump do I need for my well?
You will also need to determine the best pump size, depending on your water home needs. Pumps are rated in GPM (gallons per minute). A typical 3- to 4-bedroom home requires 8-12 GPM. When determining your home water needs, add one GPM for every water fixture in your home.
What is better 2 or 3 wire submersible well pump?
Simply put, if the deep well pump you need has a motor larger than 1.5 HP, the safest bet is to go with a 3-wire well pump so it starts and runs properly. If your application doesn’t require such a large well pump, then it comes down to a few purchase decisions.
How much does a 2 HP well pump cost?
A 2 horsepower submersible pump with a control box might cost $1,000-$1,200, not including installation. Labor typically adds about $300-$500. Budget on the low end of that for a jet pump and the high end or more for a submersible.
How long do submersible pumps last?
The average life expectancy is 10 to 15 years for a residential 3-wire and 8 to 13 years for a residential 2-wire well pump.
What is the flow rate of a 1 hp pump?
Kirloskar 1 hp Single Phase Domestic Water Pump, Max Flow Rate: < 100 LPM.
What’s the maximum temperature of water in a submersible pump?
Maximum water temperature: 120 °F/49 °C Powered by corrosion-resistant Franklin Electric submersible 4″ motor with lightning protection
What kind of motor does a submersible pump have?
FEATURES The 3200 Series submersible pumps are designed so that all parts of the pump end, including the cable guard, fall within the diameter of Franklin Electric’s industry leading submersible 4″ motor.
Which is Franklin Electric Submersible pump is the best?
The 3200 Series submersible pumps are designed so that all parts of the pump end, including the cable guard, fall within the diameter of Franklin Electric’s industry leading submersible 4″ motor. This reduced diameter pump end makes it ideal for installations where the well is considered encrusted or tight in comparison to a standard 4″ well.
What kind of pump is 90 FA 5 s?
Examples: 90 FA 5 S 4 – PE PE = Pump End Pump Size P = Plastic, S = Stainless Steel Horsepower Series Gallons or Liters per Minute 45FA3S4-PE = 45 gpm, FPS 4400, 3 hp, Stainless Steel, Pump End 25FE1P4-PE = 25 lpm, FPS E Series, 1 hp, Plastic, Pump End Examples: MODEL NUMBER NOMENCLATURE