Categories :

How do you cut and bend aluminum fascia?

How do you cut and bend aluminum fascia?

Measure 1 to 1.5 inches in on the short side of the aluminum fascia. Use the brake or combination square as your straight edge and lightly cut into the material with a blade or utility knife. The cut should be deep enough to allow you to easily bend the fascia, but not so deep that it could snap.

What do you cut fascia with?

Set the angle of a miter saw to 45 degrees so you can make clean cuts through the board. Put on your safety glasses, and position the fascia board so the corner on one end lines up with the saw blade. Turn the saw on and pull it down to cut the angle. Cut the ends of any other boards that will be on a corner.

What kind of blade Do I need to cut aluminum?

When cutting aluminum, brass or bronze you need a blade specially designed for cutting non ferrous material. These blades have a special grade of carbide for aluminum, a triple chip top grind and a zero or negative hook angle.

What is the best tool for cutting aluminum?

Tin snips are ideal for cutting soft metals like aluminum and copper, and are especially useful for cutting sheet metal, gutters, metal roofing, and studs. Thanks to their sharp blades, tin snips typically leave a smooth edge.

How is the best way to cut an aluminum soffit?

Here are some detailed instructions explaining how to cut an aluminum soffit. Set up the work table on a steady, level surface. A level surface will make creating a straight cut easier. Lay the aluminum soffit on the surface of the table with the flat side down so it doesn’t roll away.

What’s the best way to cut aluminium sheet?

Sheet aluminium can be cut without the need for a guillotine or tin-snips which tend to deform the metal. With the aid of a straight-edge and a sharp knife “score” BOTH sides of the aluminium sheet. This weakens the aluminium and creates a “fracture line”.

Is it easy to install aluminum soffits and fascias?

If you’re not afraid of heights and you have basic hand tool know-how, you’re perfectly capable of cladding the fascias and soffits on your home. As you’ll see, the thin, light aluminum trim is easy to bend and cut with inexpensive tools. Other special pre-bent parts make installation a snap.

What’s the best way to cut through aluminum flashing?

With a sharp blade, you can cut through the aluminum flashing. Aluminum flashing protects the fascia board of your home from the elements. The aluminum flashing is thin and lends itself to a variety of cutting methods.