What is L1 and L2 on a pull switch?
Two way switching means you can switch the same light fixture from two switches that are located in different sides of a room. Two way switches have a COM terminal as well as L1 and L2 terminals. When L1 is off L2 would be on. When L1 is on L2 would be off.
Are lights allowed in closets?
Light fixtures are not mandatory. The NEC does not require light fixtures in any standard closet. Adding closet light fixtures is, however, regarded as “best practice” by many builders and electricians, and properly installed closet light fixtures are will appeal to future home buyers.
How do you make a pull chain light?
To add a pull chain to a light fixture, follow these steps:
- Drill a hole at the base of the light, and add the chain to the hole.
- Finish installing the switch and secure it with a nut.
- Remove the cover and secure the black wires in the switch together, then do the wiring.
- Put your switch cover back.
How does a pull chain light fixture work?
Remove the outlet from the electrical box and wire your new electric wire up to the outlet. Remember, if this electrical outlet is attached to a switch, you must connect the wires to the constant hot side. Usually the top side is the constant hot side. Turn on the breaker power. Pull the chain and you have light!
How is a 3 way light switch wired?
Rick, the ceiling fan 3 way light switch is wired as follows: 1) one wire for the incoming power – usually the Black wire. 2) one wire for the first light (s) to be turned on – Red wire 3) one wire for the next light (s) to turn on – Blue wire.
How many wires do you need for a light switch?
1) one wire for the incoming power – usually the Black wire. 3) one wire for the next light (s) to turn on – Blue wire. The third switch postion is where both sets of lights turn of at the same time. It is best to verify the wires using a continuity tester.