What does F 06 mean on a Whirlpool washing machine?
drive motor tachometer error
The “F06” fault code indicates a drive motor tachometer error. This means the control is unable to properly detect motor speed and the machine will shut down. If the failure occurs during high-speed spin, the door will unlock after 3 minutes. Possible Causes/Procedure: Unplug washer or disconnect the power supply.
How do you clear a whirlpool error code?
To remove the code, press pause or cancel button twice and the power button once. If the code is still displayed, unplug the washer or disconnect the power for one minute. Items were detected in the washer during the Clean Washer cycle. Remove items from the drum and restart the Clean Washer cycle.
Do Whirlpool washers have a reset button?
Method 1: Unplug it The first way you can reset whirlpool washer top load is by unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again. This performs a hard reset on the machine and it will start over after you reconnect it again.
How do I clear the error code on my Whirlpool washer?
How do you clear the error code on a Whirlpool top load washer?
System error code. Press START/PAUSE once to clear the code, then press START/PAUSE again to restart washer. If the code doesn’t clear, Contact Us or Schedule Service Online. Hot and cold inlet hoses have been installed incorrectly (reversed).
How do you clear a Whirlpool error code?
How do I fix a Whirlpool F06 error?
How to Fix F06 on a Whirlpool Duet
- Touch “Pause/Cancel” twice to cancel the F06 error on the display.
- Plug the power cord back in and select a new wash cycle.
- Press “Pause/Cancel” twice again if the F06 error code resumes.
How do I clear the error code on my whirlpool washer?
Does whirlpool washer have a reset button?
How to Confirm You Have Reset Your Whirlpool Washing Machine. Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.
What is the fault code for a Whirlpool appliance?
F1-E4 – Model ID Error – Disconnect power for at least 30 seconds and then reconnect. Allow at least a minute after power has been restored and if error code reappears, replace control board (clock). F1-E5 – Calibration Shifted – Disconnect power for at least 30 seconds and then reconnect.
When to replace the Control Board on a Whirlpool appliance?
Allow at least a minute after power has been restored and if error code reappears, replace control board (clock). F1-E4 – Model ID Error – Disconnect power for at least 30 seconds and then reconnect. Allow at least a minute after power has been restored and if error code reappears, replace control board (clock).
What do you need to know about Whirlpool oven control?
Remember: Oven control (ERC) measures resistance of sensor circuit, not actual oven temperature. Replace control board (also called ERC or clock). Replace control board (also called ERC or clock). Replace control board (also called ERC or clock). Check wiring to door lock switch (the wire harness may be connected wrong).
What to do if your Whirlpool control pad is unplugged?
F2-E1 – Touch Pad (Keypad) Cable Unplugged – Check the connection between the touch pad (keypad) and control board (clock) to make sure it is secure. Select the ‘cancel’ function and wait 60 seconds.