Can you read codes on obd1?
All you need to do is find your diagnostic connector located under the dash by the driver side. You can then hook up a scanner and the codes will be displayed for you.
How do you check the codes on a 1991 Honda Accord?
You can retrieve your Honda Accord’s trouble code(s) yourself by using inserting a jumper wire at the diagnostic connector located in the passenger side kick panel. Insert the jumper wire in the 2 PIN service connector between pins 1 and 2. You should also see a 3 PIN connecter. This is used for a trouble code scanner.
What are the OBD1 codes?
GM OBD I Trouble Code Chart
| Code | Description |
|---|---|
| Code 13 | Oxygen sensor circuit open or no activity |
| Code 14 | Engine coolant temp sensor error (high temp indicated) |
| Code 15 | Engine coolant temp sensor error (low temp indicated) |
| Code 16 | System voltage too low |
How do you clear the OBD1 code on a Chevy?
Clear the codes by pulling the fuse for 15-30 seconds. FYI, it might just reset after you pull the fuse and put it back in.
What are the codes on the Honda OBD1?
The Most Common Honda and Acura OBD1 Codes Code Meaning Codes 0 and 11 Electronic control module (ECM) Code 1 Heated oxygen sensor A Code 2 Oxygen content B Codes 3 and 5 Manifold absolute pressure
Can a Honda OBD diagnostic be inconclusive?
OBD diagnostic does not have to be difficult or inconclusive. This is not meant to be a substitute for information in the factory service manuals or the product service training manuals. Turn the key to the “on” position to confirm that the Malfunction Indicator Light (MIL) functions.
What are the fault codes on a Honda?
The Fault Codes. 1 O2A – Oxygen sensor #1. 2 O2B – Oxygen sensor #2. 3 MAP – manifold absolute pressure sensor. 4 CKP – crank position sensor. 5 MAP – manifold absolute pressure sensor. 6 ECT – water temperature sensor. 7 TPS – throttle position sensor. 8 TDC – top dead centre sensor.
Where is the service check light code on a Honda?
1. Connect SCS service connector special tool No. 07PAZ-0010100, or equivalent, to service check connector located under the passenger’s side of dash. 2. Turn the ignition on. 3. MIL will indicate DTC’s by outputting a number of flashes.