How do you change a CV joint on a Hyundai Elantra?
How to Replace a CV Joint in a Hyundai ElantraRemove the hubcap from the wheel by prying it off with a screwdriver at the edge.Remove the axle nut from the axle with a 32 mm socket and a long breaker bar. Jack up the Elantra and place it on jack stands.Remove the wheels, using a lug nut wrench.
What are the signs of a CV joint going bad?
Top 5 Bad CV Joint Symptoms1) Vibrations. If there is a damaged or worn CV joint, then it will start to vibrate as the vehicle is in motion. 2) Grease on Wheel or Tire. If your vehicle has a boot that is torn, it could result in grease leaking from it. 3) Knocking Noises. 4) Loud Turning Sounds. 5) Bouncy Ride.
How long do CV joints usually last?
A CV joint doesn’t need a very regular maintenance as it can last very long. Basically as long as the protective CV joint boot itself is not damaged. It’s not rare to see a car with over 300,000 miles with its original CV-joints intact
How do I know if I need to replace my CV joints?
4 Signs of a Bad CV Axle/Half Shaft”Clicking” Noises When Turning.A Knocking Sound. Grease on the Inside or Edge of the Tires. The CV axle joint has boots that contain grease while the axle spins, keeping it from leaking. Vibration While Driving. This is a tricky one, since there are many things that could cause vibration when you drive.
How do you know when to replace CV joints?
These are the symptoms of a bad or failing CV axle shaft assemblyLoud clicking noises when turning. One of the most common and most noticeable symptoms of a bad or failing CV axle shaft assembly is an audible clicking noise when turning. Grease on edge of tire. Excessive vibration while driving.
Should I replace both CV axles at the same time?
CV joints and boots can be replaced individually, but most professional technicians and even do-it-yourselfers prefer to replace the whole halfshaft assembly with a remanufactured shaft. On a high-mileage vehicle with a bad CV joint or boot, it’s often a good idea to replace both shafts at the same time.
What does it sound like when a wheel bearing is going out?
Most people describe a bad wheel bearing as making a growling or rumbling noise (the sound is often mistaken for worn tires). Also, in some cases, a bad bearing may make a high-pitched grinding or squealing sound. In either case, the frequency of the sound will correspond to the rotation of the tires.
What are the signs of a bad wheel bearing?
What are the symptoms of bad wheel bearingsA humming, rumbling or growling noise that increases with acceleration or as the vehicle turns.A loud constant whining or grinding noise when the vehicle is in motion.Clunking noises when driving over uneven road surfaces.
How do I know if I need a new hub assembly?
Here is a list of signs if you have a hub assembly that may need to be replaced:Snapping, clicking or popping noises when cornering or making sharp turns.Grinding noise when the vehicle is moving.Knocking or clunking sensation from the vehicle.Wheel vibration and/or wobble.Poor steering control.