How does an inner CV joint work?
Inner CV joints connect the drive shafts to the transmission, while the outer CV joints connect the drive shafts to the wheels. The CV joints are needed to transfer the torque from the transmission to the drive wheels at a constant speed, while accommodating the up-and-down motion of the suspension.
How do I know if my inner CV joint is bad?
These are the symptoms of a bad or failing CV axle shaft assemblyLoud clicking noises when turning. One of the most common and most noticeable symptoms of a bad or failing CV axle shaft assembly is an audible clicking noise when turning. Grease on edge of tire. Excessive vibration while driving.
Can you drive with a clicking CV joint?
If you hear a clicking, clunking or popping noise from the front wheels, particularly while turning, it means the situation has progressed to the point where the CV joint is damaged. You can drive on a damaged CV joint for a little while, but there’s no telling how long safe operation will last.
How long can you drive on a clicking CV joint?
Now let’s get into the main question, how long is it safe for you to drive on a bad CV axle? Well, the short answer to the question is about five months, you can go longer by a month or so.
Can you repair a CV axle boot?
An inner axle CV joint boot cannot be replaced while the axle is still in vehicle. The axle assembly has to be disassembled in order to replace a boot. Pull the axle out of the car and find a nice flat, well lit, clean place to work.
How do you replace a CV axle shaft assembly?
4:10Suggested clip 109 secondsHow to Replace a CV Axle in Your Car – YouTubeYouTubeStart of suggested clipEnd of suggested clip
How do you diagnose a bad CV axle?
4 Signs of a Bad CV Axle/Half Shaft”Clicking” Noises When Turning.A Knocking Sound. Grease on the Inside or Edge of the Tires. The CV axle joint has boots that contain grease while the axle spins, keeping it from leaking. Vibration While Driving. This is a tricky one, since there are many things that could cause vibration when you drive.
What tools do I need to change a CV axle?
What Tools Do I Need to Change a CV Joint?Vehicle Jack. Removal of a CV joint requires that you jack the vehicle off the ground to allow access to remove the wheel and components from the wheel hub. Lug Wrench. A lug wrench is needed to remove the wheel and tire to access the CV joint.3/8″ Drive Socket Wrench Set. Tie Rod Puller. Hub Socket.